induction preheating oil drilling shaft

Preheating oil drilling shaft Objective To preheat a steel pipe to 500F (260C) before welding.Material Steel shaft assembly 5” to 8” OD (127-203.2mm) with a 2” (50.8mm) heat zone.Temperature 500F (260C), if higher temperatures are required, heat time ca…

induction sintering copper powder

Sintering copper powder Objective Sintering copper powder to a stainless steel shaft Material Steel shaft & shell assembly, approx 2” (50.8mm) diameter, 2” (50.8mm) tall, copper powder Temperature 1600 F (871 C) Frequency 54 kHz Equipment • …

induction heating motor

Heating motor Objective Heat steel to help bond an injection molded piece and help the reflow.Material Steel motor body, 60 x 60 x 27 (2.4 x 2.4 x 1.1) mm(in)Temperature 260C (500F)Frequency 237 kHzEquipment • Power of 20kW induction heating system, equip…

induction heat braided cable

Heat braided cable Objective Prior to cutting, heat a short section of a hardened steel cable coated with a polyethylene sheathing.Material Multi-strand braided stainless steel cable 0.5 in. (1.27 cm) OD enclosed within a polyethylene sheathingTemperature …

induction hermetically sealing glass

Hermetically sealing glass Objective Provide a hermetic seal of glass enclosed resistor to a lead Material Resistor Kovar rings, 0.1 inch (0.254cm) diameter Glass tube slightly larger than 0.1 inch (0.254cm) diameter, 0.5 (1.27) inch length Metal l…

induction tempering spring

Tempering Spring Objective Temper a spring by heating it to 300C (570F) in 2 – 4 secondsMaterial Stainless steel AISI 302 springs- different length from 60 to110 mm outer diameters 8 mm.- wire diameter from 0.3 to 0.6 mmTemperature 300C (570F)Frequency 3…

induction heat the end of catalytic converter

Heat the end of catalytic converter Objective Heat the end of lorry catalytic converter exhaust system. The assembly must be held at target temperature for 200 hours, whilst the assembly is vibrated to test the weld strength.Material SteelTemperature 842 –…

induction heat the plough discs

Heat the plough discs Objective To heat the circumference of plough discs before hot rolling (sharpening) processMaterial Flat Boron steel discs, OD 460 to 710 mm (18 to 28”) thickness 3.2 to 10 mm (8/64 to 25/64”)Temperature 725C 1335FFrequency 75 kHzEq…

induction heating steel rivets

Heating steel rivets Objective Heating steel rivets prior to head formingMaterial steelTemperature 1292 F (700C)Frequency 83 kHzEquipment • Power of 7 kW induction heating system, equipped with a remote workhead containing one 1.5μF capacitor.• An induc…

induction heat seat springs for powder coat

Heat seat springs for powder coat Objective Heat the steel spring assemblies of automotive seats to powder coatMaterial Steel wire springs ~24” (61 cm) long, 1/8 “ (3.175mm) diameter cross sectionTemperature 500 F (250 C)Frequency 57 kHzEquipment Power …