induction soldering connectors together

Soldering connectors together Objective Soldering two connectors simultaneously to a tin plated copper ground plateMaterial Tin plated copper ground plate 4” x 1.75” (101.6mm x 44.45mm), 2 connectors, one with12 pins & one with 4 pins and 60/40 solde…

induction soldering led to aluminum housing

Soldering LED to aluminum housing Objective Heat an aluminum spotlight housing to solder an LED assembly to the inside baseMaterial LED housing with copper plug, aluminum spotlight housing 5” (127mm) dia at top, 1.25” (31.75mm) dia at base, temperature s…

induction soldering ferrule to fiber optic cable

Soldering Ferrule to Fiber Optic Cable Objective To heat a gold-plated ferrule and fiber optic cable to 475F within 8 seconds for a soldering applicationMaterial Gold-plated ferrule tube, fiber optic cable, solder preformTemperature 475 FFrequency 270 kHzE…

induction shrink fitting impeller blades to shaft

Shrink fitting impeller blades to shaft Objective Heat aluminum impeller blades to 200 F (93 C) and shrink fit onto a shaft.Material Aluminum impeller blades with a .28” (7.109mm) bore, aluminum shaftTemperature 200 F (93 C)Frequency 255 kHzEquipment • P…

induction shrink fitting pulley to insert bearing

Shrink fitting pulley to insert bearing Objective Heat aluminum pulley for insertion of an inner bearing for the automotive industryMaterial Aluminum pulley 2.3” (60mm) OD x 1.6” (40mm) ID x 1” (27mm) high and inner bearing 0.7” (17.8mm) high x 1.6” (…

induction shrink fitting wrist pin into connecting rod

Shrink fitting wrist pin into connecting rod Objective Assemble connecting rods with a more accurate control of the heatMaterial Rod has an OD of .9125” (23.18mm), knuckle has an ID of .9125” (23.18mm) with an interference of .0001” (.0025mm). Knuckle a…

induction soldering steel connectors

Soldering Steel Connectors Objective Heat an assembly of small, gold-plated steel connectors to a brass block. Material Approx. 1/8” (3.2mm) diameter gold-plated steel connectors, 1”(25.4mm) square x 1/4” thick brass block Temperature 600F(315.6C)…

induction heating inconnel susceptor

Heating Inconnel Susceptor Objective: Heat an Inconnel susceptor to 19500F in less than one (1) minute for heating jet engine fan blades. This approach is to be used, instead of directly heating the blade, since improved temperature uniformity will be achi…

induction bonding plastic handle to knife

Bonding plastic handle to knife Objective Bonding handle of a stainless steel surgical knife into a plastic handle Material Plastic tool handle, 0.125” (3.18mm) diameter steel knife Temperature 450 F (232 C) Frequency 390 kHz Equipment • Power of…

induction heating graphite susceptor

Heating Graphite Susceptor Heating Graphite SusceptorObjectiveTo Heat a graphite susceptor to 1100C in an inert atmosphere of Nitrogen and Hydrogen. The susceptor is to be used for metal oxide chemical vapor deposition (MOCVD) crystal growth experiments. V…